User manual

DVR USER MANUAL | 1/40
CHANNEL SAFETY SYSTEMS t: 0845 884 7000 | w: www.channelsafety.co.uk
We introduced setting PTZ parameters previously in section 6.3.24 – PTZ Set. Here we will discuss how to operate
the PTZ controls.
Click the [ ] icon to enter into [PTZ control] menu shown as Picture 6-56. Now users can control the cameras
with Pan, Tilt and Zoom capabilities.
Click [Zoom-/+] button to zoom in / out the image; Click [Focus -/+] button to focus the image; Click [Iris -/+]
button adjust iris to open or close.
Cruise Set
Open auto cruise function on the PTZ setting menu if you want to setup cruise function (system default: off), and
set up cruise channel, cur point and total quantity and stop time etc
How to set pre-set point
Total: set up pre-set point quantity
Cur Point: indicates starting point cruised. System default point is 01. The model support up to 255 pre-set points.
Stop time: sets the stop time at each point
GO TO: allows you to go to a specific preset point.
Set: allows you to set a set of specific preset points of a PTZ camera.
1. Select a camera you desire to set a preset point;
2. Adjust the camera in a desired direction;
3. Click [Set] to set the point as preset point;
4. Click [Save] to save the preset point;
5. Follow the above step to add one more preset point.
Save: save all the preset points
Clean: allows you to delete one selected preset point.
Note: Up to 254 pre-sets per one camera can be stored. However, the actual preset quantity differs depending
on the PTZ performance.
Picture 6-56
6.6 PTZ Control