Instruction manual

83
Setting the Send E-Mail:
This setting is used to automatically send a notification e-mail to a specified address when an alarm occurs.
(Memo: The DVR will be forcibly restarted if a value on this screen is changed.)
Send E-Mail: Sets whether to enable/disable e-mail sending function.
Transmission Mode: Enables sending image of the channel that triggered the alarm when an alarm event
is triggered.
IP Notification: To send a notification e-mail when the DVR IP address is changed, check the checkbox.
Event Alarm: Sets whether to enable/disable sending e-mail reports on the channel that triggered the
alarm when an alarm event is triggered.
Mail Address: Input the destination address.
Mail Server Name: Input the SMTP server name as well as the user ID and password.
Return Mail Address: Set the source e-mail address to be notified to the destination.
SUBMIT: Save surely by pressing this button after setting the value.
9-7-5-5. NTP
Setting the NTP: It allows synchronizing the time using an internet of LAN NTP server.
NTP: Sets whether to synchronize the time using NTP server or not.
Primary SNTP Server: Input the NTP primary server address.
Secondary SNTP Server: Input the NTP secondary server address.
Time Zone: Select the time zone.
Connection Mode: Select the connection mode to NTP time server.
Time: Synchronize the time at the time that is set.
Interval: Synchronize the time by hours that is set
Connection Period: Set the connection period.