Instruction manual

26
button (◀ ▲ ▶ ▼) on the remote control and press OK button.
N-0840L and N-1640L support up to 2 Spot Outs.
Item Description
SPOT OUT 1
If the Video Output is set to CVBS On, the Spot Out 1 works as CVBS.
If the Video Output is set to CVBS Off, the Spot Out 1 supports as
Spot Out function and it supports All channel live mode only.
SPOT OUT 2
Regardless the Video Output setting, N-0840L and N-1640L support
Spot Out 2.
SPOT TYPE
Spot out 2 supports FULL type. (1 channel only)
SPOT ON EVENT
Enable/Disable display of the channel when an event is active.
SPOT EVENT
DWELL TIME
Set the dwell time for the display of the event activated channel.
(1-10sec)
SEQUENCE
Enable/disable sequential display of spot channel in full screen.
If select ON, spot channel selection screen is displayed.
SEQ-DWEL TIME
Set the dwell time for the spot channel display.(1-10sec)
SPOT CHANNEL
Select a channel for spot monitoring using the mouse or the control
button (◀ ▲ ▶ ▼) on the remote control and press OK button.
3-4-3 PTZ Setup
To control the PTZ functions of the camera, connect a controller to the RS-485 port.
① Connect the RS-485 cables of PTZ camera to the RS-485 port on the rear panel.
② Press the PTZ menu button. Then PTZ menu screen is displayed.
Figure 3.4.4. PTZ Control Setup Screen