Instruction manual

24
system will reboot.
When it changes the VGA resolution to 1280x1024, the CVBS
is set to Off.
ALARM OUT
Set the sensor, motion, and video loss for each alarm.
PTZ
Set the PTZ camera speed, number, type and ID.
SPOT-OUT
Set the all details for spot monitoring. 4ch supports 1 spot-out
and 8/16ch supports up to 2 spot-outs.
CHANNEL
Select specified channel for motion zone setup.
MOTION ZONE
Select either Full Zone or Partial Zone for motion sensing.
MOTION SENSITIVITY
Set the motion sensitivity for the specified channel.
Control the motion sensitivity from 1 to 9.
KEY TONE
Enable/disable key tone.
REMOTE CONTROL ID
Select an ID of remote control.
1. Select ID.
2. Press the same number as ID set in DVR on a remote
control.
3. Then icon will be displayed on Live screen of DVR that
respond to the remote control.
The options are from 0 to 99
SENSOR
Select sensor NO from 1 to 4
TYPE
Set the type of sensor for the specified channel. Options are:
OFF, N/O (normal open), and N/C (normal closed).
3-4-1. ALARM-OUT
Figure 3.4.2. ALARM-OUT setup screen