Install guide

CM6000 Install Guide
Alarm and Starter System
www.firstechonline.com | www.compustar.com
Installation Basics CM6000
If you are new to installing Firstech Series Remote Starts and/or Alarms, we highly recommended that you
thoroughly review this manual to installing your first unit.
Key Points to Consider Before Installation:
You must code remotes to this system before anything will function. Program remotes by cycling the ignition
ON / OFF five times within seven seconds and press and release button 1 (half second) on the first remote,
and then press and release button 1 (half second) on the second remote.
RPS Touch (Touch Remote Paging Sensor):
The optional RPS that has four main functions; (1.) Status LED, (2.) Remote notification when triggered, (3.)
Auto unlock/alarm disarm when a user specific 4 digit knock code is entered via tapping sensor through the
windshield. (4.) You can also relock your vehicle if equipped with an RPS Touch sensor.
DAS Sensor:
The DAS sensor monitors forward movement for remote starting manual transmissions, dual stage impact,
and auto adjusting tilt sensor. See the DAS Sensor section of this manual for details.
Internal green/white loop must be cut for AUTOMATIC transmission vehicles.
By default, the units come in MANUAL transmission mode. You will need to cut the green/white loop inside
the control module if you are installing the unit in a AUTOMATIC transmission.
Tach learning procedure:
Learn tach by: (1.) Starting the vehicle with the key, (2.) Press and hold the foot brake, then (3.) Activate the
remote start sequence - one chirp and parking light flash indicates that the vehicle tach signal has been
successfully learned. Three chirps and three parking light flashes indicate that the control module failed to
see a proper tachometer signal. (These units have the option for Tachless and 1.5 second assume cranking).
New Option Menus:
It is important to familiarize yourself with all the options as it will save time in most applications. For in-
stance, Option 1-04 controls the double pulse unlock feature on all CM6 series control modules.
Programmable Output Channel (POC) Must have Option Programmer OP500
All control modules come with 9 programmable outputs that can be configured 19 different ways. It is
important to familiarize yourself with the POCs as it will save time in most applications.
Internet updatable processors Visit www.firstechonline.com
All CM6 series units are equipped with some of the most powerful processors available today. This flexibility
allows for on-demand internet updating capabilities in the event of a version update or change.
Copyright 2011 Firstech, LLC.
Page 5