Specifications

Channel Master Operation Manual
page 30 Teledyne RD Instruments
e. If you have not already read the Read me file, click the Read me button.
Click Start to begin the firmware upgrade.
f. Select the Serial port your PC uses to communicate with the Channel
Master.
NOTE. If you do not see this port listed, it may be in use by another
program such as WinHADCP or BBTalk. If this happens, close the port
and then close the firmware package and start it again.
g. Select the BAUD rate your Channel Master uses when it wakes up. Par-
ity, Data bits, and Stop bits are rarely changed from their default values,
so leave them as they are.
h. Click Connect. If all is well, a wakeup banner will appear in the Con-
nection message window and the indicator light will turn green. If this
does not happen, try again with other settings or click Auto Detect.
When the light is green, click OK to continue.
NOTE. Once the indicator light is green, you can change the
communication settings. If you do, the new settings are sent to the
Channel Master and saved with a CK command. They become the new
wakeup settings.