Specifications

Channel Master Operation Manual

P/N 95B-6001-00 (February 2006) page 13

6 Testing Your Channel Master

Use the following steps to test the Channel Master.

a. Interconnect and apply power to the system as described in “Setup the

Channel Master,” page 10.

b. Start the BBTalk program (for help on using BBTalk, see the RDI Tools

User’s Guide).

c. On the File menu, click Break (you can also press the End key to send

a break or use the Toolbar and press the B button). You should see the

wakeup message appear on the log file window.

Horizontal ADCP

Product Version: CM02.04

d. At the “>” prompt in the communication window, enter the direct com-

mand CR1 then press the Enter key. This will set the Channel Master to

the factory default settings.

e. At the “>” prompt in the communication window, enter the direct com-

mand CK then press the Enter key. This will save the factory default

setting.

f. At the “>” prompt in the communication window, enter the direct com-

mand PS0 then press the Enter key. This will display the Channel Mas-

ter system configuration data.

>PS0

Serial Number: 5813

Frequency: 1228800 Hz

Configuration: HADCP: 2-beam velocity + vertical stage.

Transducer Type: PISTON

Beam Angle: 20 Degrees

Beam Pattern: CONVEX

Sensors: TEMP PRESS TILTS

Product Version: CM02.04

CPU Firmware: 28.28f

FPGA Version: 2.00.003

Sensor Boot: 32.02

Sensor Firmware: 33.03

Board Serial Number Data:

24 00 00 00 32 23 40 23 SNS72B-1000-00A

15 00 00 00 31 65 DC 23 PIO72B-2001-00B

A8 00 00 00 10 66 B6 23 XDR71B-1007-00A

E3 00 00 00 1F CD 99 23 PER72B-2006-00X

DC 00 00 00 31 CA 43 23 RCV72B-2003-09A

90 00 00 00 31 AB 7F 23 DSP72B-2002-00A