Instruction and Assembly Manual .90m, 1.0m & 1.2m SMC ANTENNA SYSTEM WITH AZ/EL CAP MOUNT TYPE 900 - .9m TYPE 100 - 1.0m TYPE 120 - 1.2m SMC ANTENNA WITH AZ/EL CAP MOUNT (UK) Limited Premier Business Park, Croft Head Road, Off Philips Road Whitebirk Industrial Estate Blackburn, Lancashire England BB1 5UE (0254) 680444 ■ Fax (0254) 672299 1315 Industrial Park Drive, P.O. Box 1416 Smithfield, N.C. 27577 U.S.A. (919) 989-2242 ■ Fax (919) 989-2200 8000284 Rev.
VSAT ANTENNA/MOUNT/LNB LIMITED TWELVE (12) MONTH WARRANTY This CHANNEL MASTER® equipment is warranted to be free from defects in material and workmanship under normal use and service. CHANNEL MASTER shall repair or replace defective equipment, at no charge, or at its option, refund the purchase price, if the equipment is returned to CHANNEL MASTER not more than twelve (12) months after shipment.
DANGER!!! WATCH FOR WIRES! Installation of this product near power lines is dangerous. For your own safety, follow these important safety rules. 1. Perform as many functions as possible on the ground. 2. Watch out for overhead power lines. Check the distance to the power lines before starting installation. We recommend you stay a minimum of 6 meters (20 feet) from all power lines. 3. Do not use metal ladders. 4. Do not install antenna or mast assembly on a windy day. 5.
GROUND POLE INSTALLATION 2³⁄₈” O.D. x 72” LONG 2³⁄₈" O.D. 2³⁄₈" O.D. DEEP FROST LINE FOUNDATIONS PIER FOUNDATIONS NOTE: 48" may be increased, concrete and length of rebar will increase accordingly. ,, ,, ,, , ,, ,, ,, , ,, ,, ,, ,, ,, ,, 1" to 2" SLOPE FOR WATER RUN OFF 37 ,,,, ,, ,, ,,,, ,, ,, ,,,, ,, ,, 1" to 2" SLOPE FOR WATER RUN OFF 37 72 72 GRADE 48"(SEE NOTE) 36 OVAL END 2" MIN. DIA. d BELOW FROST LINE BELOW FROST LINE (4) #3 x 24" MIN.
GROUND POLE INSTALLATION 3” O.D. x 68” & 72” LONG 3" O.D. 3" O.D. PIER FOUNDATIONS ,, ,, ,, ,, ,, ,, ,, ,, ,, ,, ,,,, L GRADE (SEE NOTE 2) BELOW FROST LINE PIER FOUNDATIONS WIND VEL. .90M 80 MPH 90 MPH 110 MPH 110 MPH 125 MPH 1.0M 80 MPH 90 MPH 110 MPH 110 MPH 125 MPH 1.2M 80 MPH 90 MPH 110 MPH 110 MPH 125 MPH DIM “L” DIM “d” CONC VOL. 37” 9” 11” 13” 15” 18” 1.5 FT3 2.2 FT3 3.0 FT3 4.0 FT3 5.8 FT3 37” 10” 13” 15” 17” 20” 1.8 FT3 3.0 FT3 4.0 FT3 5.2 FT3 7.
ASSEMBLY AND INSTALLATION The AZ/EL Cap Mount can be installed on a 2³⁄₈” or 3” O.D. ground tube, roof, or wall mount depending on model. The appropriate mount should be assembled and in place before installing the AZ/EL cap. MOUNT ASSEMBLY As the AZ/EL cap mount is factory preassembled, there is no assembly required for the mount. 1 ASSEMBLING ANTENNA TO CAP MOUNT Install four M8 x 60mm (2³⁄₈”) carriage bolts (1) into holes in center of reflector and assemble to cap mount flanges. (Reference Fig. 2.
12 CLAMP SURFACE 11 13 9 6 5 14 6 4 8 6 7 9 15 7 10 Junction Block (9) FIG. 2.2 - INSTALLATION OF FEED AND FEED SUPPORT LEGS TO ANTENNA IMPORTANT: Sealing RF coaxial connector: The copper-plated center conductor in the RF coaxial cable, which connects receiver to LNB, can experience electrolysis corrosion at the LNB connector. Moisture and DC current cause this type of corrosion.
ANTENNA ALIGNMENT PROCEDURE Alignment with the satellite is obtained by setting polarization, elevation and azimuth. Charts 1, 2 & 3 are to determine the values for your earth station antenna site. “∆L” is the difference between the earth station antenna site longitude and the satellite longitude. Use “∆L” and your earth station latitude to obtain polarization, elevation or azimuth setting.
POLARIZATION CHART " L" IS THE DIFFERENCE BETWEEN THE EARTH STATION ANTENNA SITE LONGITUDE AND THE SATELLITE LONGITUDE NORTHERN HEMISPHERE POLARIZATION CHART SIGN VALUES (+ OR -) SOUTHERN HEMISPHERE 90 ANTENNA SITE WEST OF SATELLITE LONGITUDE ANTENNA SITE EAST OF SATELLITE LONGITUDE + + - 80 ANTENNA 70 POLARIZATION + OR – (SEE ILLUSTRATION) + – FEED 60 Feed Rotation (Facing Antenna) For + Polarization, Rotate CCW (Counter Clockwis For - Polarization, Rotate CW (Clockwise) 50 75° 40 60° 40°
ELEVATION CHART " L" IS THE DIFFERENCE BETWEEN THE EARTH STATION ANTENNA SITE LONGITUDE AND THE SATELLITE LONGITUDE 50° 90 125° 47.5 ° 120° 1 15° 11 0° 105° 100° 95° 90° 85° 80° 75° 70° 65° 50° ° 47.5 45° 45° ° 42.5 42.5 ° 5° 80 40° 37.5 ° 10° 40° ° 37.5 35° 3 5° 32.5 ° 70 15° 32.5° 30° 30° 27.5 ° 20° ELEVATION IN DEGREES 60 27.
AZIMUTH CHART EARTH STATION ANTENNA AZIMUTH (IN DEGREES) " L" IS THE DIFFERENCE BETWEEN THE EARTH STATION ANTENNA SITE LONGITUDE AND THE SATELLITE LONGITUDE NORTHERN SOUTHERN HEMISPHERE HEMISPHERE 180 0° 180 0 360 10 350 20 340 30 330 40 320 50 310 60 300 70 290 80 280 90 270 5° 190 170 200 160 210 150 220 140 230 130 240 120 250 110 10° 15° 20° 25° 30° 35° 40° 45° 50° 55° 60° 65° 70° 260 90 270 270 EAST WEST 75° 0 5 10 15 20 25 30 35 40 45 50 55
PARTS AND HARDWARE LISTING 2 3 1 16 17 19 18 3 26 17 2 25 19 2 20 3 23 24 21 2 3 17 22 23 FIG. 4.0 - AZ/EL CAP MOUNT ITEM PART NO.
PARTS AND HARDWARE LISTING 12 CLAMP SURFACE 11 13 9 6 5 14 6 4 8 6 7 9 15 7 10 Junction Block (9) FIG. 4.1 - ANTENNA, ANTENNA FEED (LNB) & FEED SUPPORT LEGS ITEM PART NO. DESCRIPTION 4 4 4 5 5 5 6 6 6 7 8 9* 10 11* 12* 13* 14* 15 2020329-07 2020329-02 2020329-03 3040642-02 3040646-02 3040681-02 6010100-05 6010100-06 6010100-07 2060008-01 2509010-01 3040667-04 2502700-01 3040663-01 2050610-20 2480600-01 VARIES 2060009-01 LEG BOTTOM (.90m) LEG-BOTTOM-FEED (1.0m) LEG-BOTTOM-FEED (1.
HARDWARE SORTER M8 x 60mm Round Head Square Neck Bolt Item 1, PN 2070022-01 M6 Tapping Screw Item 15, PN 2060009 M6 x 30mm Hex Head Bolt Item 7, PN 2060008 M8 x 20mm Round Head Square Neck Bolt Item 19, PN 20700022-03 M4 x 12mm Phillips Head Screw PN 2430070-04 M4 x 10mm Phillips Head Screw PN 2430070 M8 x 35mm Round Head Square Neck Bolt Item 20, PN 2070022-05 Washer, Flat - ¹⁄₄" x ³⁄₄" OD Item 10, PN 2502700-01 Washer, Flat - ¹⁄₄" x ⁷⁄₈" OD Item 8, PN 2509010-01 Hardware illustrations are true s
