User's Manual

Website:www.sunvote.com.cn TechSupportTel:008673185125959816
Version:V1.0Date:20160815 Email:support@sunvote.com.cn
Enable multi base stations in the application software: set base station ID and connect. The
connectionstateshows“successful”ifconnectedsuccessfully.
Copyrigh
tNotice
Allinformationrelatedtotheproductsandtechnologyinthisdocumentbelongstothecopyrightof
CHANGSHASUNVOTELIMITED.Anyonewhobrowses,reproduces,printsanddistributesthisdocument
withoutdueauthorizationmightconstituteaninfringementofcopyright.
Thet
echnicalp
arametersinthisdocumentmayvaryduetotheactualuse,environment,servicelifeand
productionbatches.Ifyouhaveanydoubt,pleasedonothesitatetoconsultCHANGSHASUNVOTELIMITED
staff .
CHANGSHASUNV
O
TELIMITEDreservesthefinalrightofinterpretationofthisdocument.
FCCWa
rning
AnyChangesormodificationsnotexpresslyapprovedbythepartyresponsibleforcompliancecouldvoidthe
usersauthoritytooperatetheequipment.
Thisdevicec
omplieswithpart15oftheFCCRules.Operationissubjecttothefollowingtwoconditions:(1)
Thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemustacceptanyinterferencereceived,
includinginterferencethatmaycauseundesiredoperation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.