Owner`s manual

ACTIVE BUTTONS ILLUMINATED

You will notice that in any given state of operation some of the buttons on the Control Panel are not

illuminated. The advanced programming of the KN-8828P-2K assists the user by illuminating only those

buttons which are currently active. For example, when you have added six “Pluses” during the roast you

have reached the maximum number available and at that point the “+” button is no longer illuminated.

FACTORY PROGRAMMED SAFETY

There are three separate safety points programmed into the KN-8828P-2K:

1) If the KN-8828P-2K displays a temperature of 374 F. (190 C), the unit will alert you

with warning beeps. If you do not press the “Enter” button within 30 seconds, the beans will

be automatically ejected. Pressing the “Enter” button continues the roast as programmed.

2) When the KN-8828P-2K displays a temperature of 395 F. (202 C), the roaster will again alert

you with warning beeps. If you do not press the “Enter” button within 30 seconds, the beans

will be automatically ejected. Pressing the “Enter” button continues the roast as programmed.

3) When the KN-8828P-2K displays a temperature of 428 F. (220 C), the beans will be immediately

ejected. There is no override for this safety function.

SELECTING OPERATING MODE

The KN-8828P-2K operates in either “Auto” mode or “Manual” mode. Auto

mode operates based on a pre-programmed proﬁle. Manual Mode operates using one

of ten Programs that are used to control all aspects of operation.

As shown in this ﬂow chart, when you ﬁrst power up the KN-8828P-2K by plug-

ging it in and pressing the “POWER/START” button you have the choice of which mode

to use. The default is “AUTO.” Use either the “<” or the “>” button to choose the mode

you desire. The Display will show the selected mode. Press “”ENTER” to begin using the displayed mode.

CHAFF TRAY SAFETY SWITCH

The Chaff tray has a safety switch that will not allow the operation of the roaster unless

the chaff tray has been emptied after a roast. Even is the machine is unplugged the tray still

needs to be removed for emptying before operation. An animation of the chaff tray appears

in the message Center to remind you.

SELECTING TEMPERATURE MEASUREMENT UNITS

The KN-8828P-2K Coffee Roaster can be set to display temperatures in Fahrenheit or Celsius. To

change the displayed units follow these steps. This only needs to be done once unless you desire to change

the standard in the future.

NOTE: Throughout the following step-by-step sections, black and yellow

highlighted

words refer to the buttons on the control panel of the same name

Press and hold the SET/SAVE button

While holding the

SET/SAVE button in, plug the power cord into an appropriate outlet. Hold the

button for a few additional seconds. The screen will change to purple. You can now release SET/SAVE.

The display will show the temperature standard. Change it by using the “

+” or “-”

button. The choices are either “C” for Celsius or “F” for Fahrenheit.

When the preferred temperature standard is displayed, press BACK/EJECT.