User Manual

PRIMEX/CHANEY INSTRUMENT CO.

Hong Kong Primex Asia Limited Shenzhen Representative Office

REV (1.3) DATED 28/12/05

Page 8 of 10

5.2.6 After press “Clear” button, the menu will be back to normal mode from setup mode

and display “Alarm” icon.

5.2.7 After finished setup maximum / minimum and exit setup mode, the receiver will

display “Alarm” icon and enable alarm function after 15 minutes.

5.2.8 After set the maximum, the unit will auto adjust the minimum and make it less than

the maximum.

5.2.9 The maximum could be set within the concessional temperature range.

5.3 If alarm function is enabled, the unit will raise the audio alarm when the temperature

value more than the max or min.

5.4 The unit will alarm for 1 minute. Then the unit will beep for three times after each 1

minute.

5.4.1 For alarm1, see the below figure,

5.4.2 For alarm2, see the below figure,

5.4.3 For alarm1 & alarm 2(for example: first the alarm1 generate, then the alarm2

generate)

5.5 When the unit raise an alarm, the “ ” icon will be flash.

5.6 Stop alarm when the unit is disabled alarm function.