User Manual

PRIMEX/CHANEY INSTRUMENT CO.

Hong Kong Primex Asia Limited Shenzhen Representative Office

REV (1.3) DATED 28/12/05

Page 6 of 10

5.1.3 And then press Alarm1 is to enter Min. setup mode (then with key tone), the Min.

will be displayed as the below figure,

5.1.4 Press Alarm1 again under the above mode (then with key tone). The unit will be

back to normal mode and display as the below figure,

5.1.5 If no any button is pressed within 10 seconds, the menu will be back to normal

mode from setup mode.

5.1.6 After press “Clear” button, the menu will be back to normal mode from setup mode

and display “Alarm” icon.

5.1.7 After finished setup maximum / minimum and exit setup mode, the unit will enable

alarm function after 15 minutes.

5.1.8 After set the maximum, the unit will auto adjust the minimum and make it less than

the maximum.

5.1.9 The maximum is to be set within the concessional temperature range.

5.2 Channel 2 alarm setup mode