User Manual

PRIMEX/CHANEY INSTRUMENT CO.

Hong Kong Primex Asia Limited Shenzhen Representative Office

REV (1.3) DATED 28/12/05

Page 4 of 10

4. Operation

4.1 Power on / Reset

a. When power on the receiver, it will fully display with beep as the below figure,

b. Then the receiver starts to receive the signal from the sender.

4.2 BUTTON FUNCTION

4.2.1 ALARM 1

a. To press Alarm1 button switch to on/off alarm function. The “ALARM” icon is displayed;

the unit will enable alarm function after 15 minutes.

b. Press and hold Alarm1 for 2 seconds is to enter channel 1 alarm maximum setup

mode.

4.2.2 ALARM 2

a. To press Alarm2 button switch to on/off alarm function. The “ALARM” icon is displayed;

the unit will enable alarm function after 15 minutes.

b. Press and hold Alarm2 for 2 seconds is to enter channel 2 alarm maximum setup

mode.

4.2.3 + /-

Press “+” or “–” to change values for alarm – press and hold for 2 seconds for rapid scroll

through of values.

4.2.4 CLEAR

Press “CLEAR” is to clear the max and min in the memory.