User`s guide

8 DiViS
www.DiViSdvr.com
3-1-2. Setup Connection Mode
•Single: Check and select one of registered sites to access
one site of DiVIS DVR.
•Use Auto Login: The DiViS Net will log in automatically
using the currently registered ID.
•Use Auto Quality Resolution – Use Auto Quality
Resolution is a function for adjusting image quality
according to the number of channels displayed on a
screen. The quality of the images will suffer as the
number of channels displayed increases (i.e. 16 or 36
channels). However, the difference is hardly noticed due
to the corresponding decrease in the size of the
displayed channels.
This function helps the user receive image data faster under
poor running environments, such as low-end system or low-
speed Internet connection, by increasing the transmitting
speed of the data.
On the other hand, the user hardly notices any change as a
result of this function if the DiViS DVR system is running
under high-quality environments, such as high-end system or high- speed Internet connection.
Note: This function can put the DiViS DVR system under heavy stress.
•Multiple: Select to access multi-sites upon log in.
Connection must be defined as following.
- Site name: Choose a site to connect to from the drop-
down list.
- Camera: Choose a specific camera number, all, or partial
-- All: Choose to display all available cameras sequentially
from the selected site.
-- Partial: Choose to display multiple cameras from the site.
Note: Specific camera numbers must be assigned under
“Camera(s).” For example, position 8 will display cameras 1,
3, 6, 9, and 14 sequentially from the site, “Office.”
“Save” must be clicked for the changes to take effect.