User`s guide

31 DiViS
www.DiViSdvr.com
4-4-3. Using Dial-Up Connection
• On DiViS DVR system
Make sure that the Dial-Up Server is configured and that the DiViS DVR Main software is running.
• On DiViS Net System,
Click “Start > Setup > Control Panel > Network Connection.”
The icon for the Dial-Up will be
displayed with the name assigned
during configuration process. Double
click on the icon. The desired
connection in the picture to the left
would be the connection named “dvr.”
Verify the user name, password, and Dial number.
Then click “Dial” to establish the connection.
If the connection fails, check modem drivers on both the DiViS DVR
system and the DiViS Net System, under “Device Manager” (My
Computer (right click) > Manage), and check the Dial-Up server and
the client setting.
Once connected, execute the DiViS Net software and register a site with following information.
Method: TCP/IP
Address: the virtual IP registered at ‘From’ in Dial-Up server.
Username & Password: user information registered on the DiViS DVR system.
After entering the above site information, the DiViS Net System is ready to connect to the DiViS DVR system
via Dial-Up Connection.
Note: Due to limited transmission speed, the images will load very slowly.