User`s guide

29 DiViS
www.DiViSdv
r
.com
5-5. Sensor
• Select sensor to use: Enable or disable the selected sensor.
• Sensor location: Description of the place where the sensor is located.
• Sensor type: Select the type of the sensor.
• Connected camera: Assign a camera that will record when the sensor is triggered.
• Check time: Length of recovery time allocated to a sensor after it has been triggered.
• Emergency notify: If “Remote notification of events” was enabled in “System” setup, it will automatically send
remote notification to the designated Net client software regardless of the notification schedule.
• Sensor trigger - Notification: Choose event for sensor detection (Refer to 5.7. Event Setup
)
• Relay Information Settings
- Relay Information Settings: Configures relay operation.
- Relay Index: Select a Relay to configure. (‘Select All’ applies the same setting to all relays)
- Relay Name: Set Relay name (ex. Front door siren)
- Relay Trigger Use: If Relay is triggered manually, it will be activated only for selected “Latch time”
All changes will only be applied if “Save & Close” or “Apply” button is clicked.