User`s guide

22 DiViS
www.DiViSdv
r
.com
5-4. Camera
5-4-1. General
: If selected, the settings selected
in “General”, “Schedule”, “Color &
Motion” will be applied to all the cameras (Note:
some setting are not affected by “Select All”).
If you would like to customize each camera
uniquely, select a camera from the buttons on
the left of the menu (1-32) FIRST, then modify
the following options
• Enable Camera: Enable/disable camera. (Camera channel 1 is always enabled.)
• Basic setting
- Camera name: Assigns name of the camera. (Name will be displayed in Main screen.)
- Resolution: Choose the desired resolution for the camera. (Note: higher resolution size of the recording
will lead to a lower frame rate.)
• Adjust camera frame rate
- Maximum averaged frame rate: Sets the recording frame rate to the maximum available rate for each
channel.
- Select frame rate by camera: Allows manual setting of the frame rate per second.
Normal: Frame rate when the camera is scheduled as normal.
Event: Frame rate when the camera is scheduled as Motion or Sensor.
If the camera is scheduled as Normal & Event, Normal frame rate will be applied without event, and
Event frame rate will be applied when motion or sensor input is detected.
• Security
- Hide camera (Display): If selected, current camera will not output its images on the monitor.
- Remove from CCTV display: If selected, current camera will not output its images through Composite-
Out (For LIVCAP and D1 series, this option may not take effect if “TV-out auto switching interval” is set to
“Normal”).
- Remove from network display: If selected, current camera will not be displayed on remote connections.
(Note: “Hide camera (Display)” also hides images from being displayed on TV-Out. “Remove from
CCTV display” feature is not supported under AMX, D1, H.264 Series board.)
• Compress format & rate: Change the compression rate. (Moving bar to the left decreases the size of the
image file, but at the same time quality of image will degrade.)