User`s guide

21 DiViS

www.DiViSdv

.com

- Allow remote connections: Allow users to log on the system from a remote location through the network.

-- Code: Give a unique combination of case-sensitive

alphanumeric characters, maximum of 10 characters.

This field is required for IP Server.

-- Bandwidth Control: Adjust bandwidth depending on the

connection type. It is recommended to reduce the bandwidth in

order to increase the transmission speed. However, the quality

of the images will degrade. This control is not available on

AMX/D1 series.

-- Remote notification of events: Enable and assign remote client

information to be notified. The system is capable of sending a

warning message to the remote client when motion or sensor

is detected. The remote client is notified through sound, and it

will popup if running and minimized. In order to notify the

remote client, make sure to configure the IP address or Code

in “IP / Code”.

--- Method: Select between TCP/IP and Server (Server when

using IP Server)

--- IP / Code: Give IP address or Code (Code when using IP

server) of remote client to send Notification.

-- Use IP Server: In case of using IP server, check the box. Since

IP Server uses Code to identify DVR system rather than its IP address, it is possible to connect to a DVR

system that has a dynamic IP address (Code name must be unique for each DVR system.)

--- IP Server: IP address of system in which IP Server program is running (Server must use static IP address.)

--- Notify interval: Update the IP address of current DVR system on the IP server once in every time interval.

-- Prevent IP: Blocks IP addresses registered on the block list.

--- Add, Delete, Modify: Add the IP address entered on “IP Add” field, delete or modify the selected IP address

of the list.

- Internal program CD burn: Use CD

Burn Program in DVR Program

(Windows XP required).

- External program CD burn: Click “Browse” button to choose external CD Burn Program (CD-RW). CD burning

program will start once CD Burn button is selected in Search program.

- Setting log off timeout: Set the length of time each user can stay logged in without performing any operations

(including mouse movements).

All changes will only be applied if “Save & Close” or “Apply” button is clicked.