User`s guide

20 DiViS
www.DiViSdv
r
.com
- Use FTP Server: Transmitting image data to FTP server when an event (motion detection and sensor relay)
occurs. Press “Properties” to set up.
-- Address: Enter FTP address.
-- Port: Enter FTP Port Number.
-- ID: Enter ID.
-- Password: Enter password.
-- Passive Mode: Select only if FTP server is passive mode.
- Warning on disk full: Select this feature to receive popup warnings when disk is full.
-- Warning at value
--- Last volume: Warning on the last volume of database.
--- Specify the used percent: the system will send a warning
when it reaches x percent, x being 60~99%.
-- Warning at disk
--- Total disk: Displays warning based on total disk space.
--- Current disk: Displays warning based on current disk space.
-- Warning at a term: Allows setting up a warning at a
scheduled time and date.
--- Start date: The date in which the warning countdown begins
--- Warning time: The hour in which to issue the warning
(military time)
--- Saving duration (days): The duration of the countdown.
-- Saving options on warning
--- Save on warning: Keep recording regardless of warning messages.
(Once database is full, it will start overwriting from the first volume.)
--- No save on warning: Stop recording once warning message is on
-- Filled Disk: Configure an event when message shows up. (Refer to 5.7. Event setup)
- Warning on disk fail: Select to display a warning message if any problem occurs while writing data on disk.
Press “Properties” to set up.
-- Warning message popup: Displays a message box when it
cannot write data on disk.
-- Disk fail event: Triggers an event when the system fails to
write data on disk.(Refer to 5-7. Event Setup)