User's Manual

Scantech-ID Shuttle
C
SG-15
Colour
61
SG-15 Command Set
COM
MAND
ESC
(
1B
)
16
HEX DEC DESCRIPTION
ESC 24 36 $
reserved
ESC 25 37 % Clear Display
Clear the Display and move the cursor to the topleft position
ESC 27 39 ' Set Cursor Position
Set the cursor position on the display. Note : The actual pixelposition
depends on the currently selected font set:
Every x-position is a multiple of 8 pixels.
Every y-position depends on the currently selected font set (height of 12 or
21 pixels)
Pos : 0 - 15 (0x30 - 0x3F)
Line : 0 - 4 (0x30 - 0x34)
<POS>
0x30-0x3F
<LINE>
0x30-0x34
ESC 2C 44 , Set Pixel Position
Set the current pixel position on the display.
This allows a text to be printed anywhere on the display.
Pos : 0 - 127 (0x30 - 0xAF)
Line : 0 - 63 (0x30 - 0x6F)
Note : A character will only be displayed on the current coordinates if it fully
fits on the screen.
<POS>
0x30-0xAF
<LINE>
0x30-0x6F
ESC 2E 46 . Align a string of text
Print a text, using the current font set, on a calculated postion on the
screen.
<Align> can be one of the following values:
0x30 - Left Top
0x31 - Center Top
0x32 - Right Top
0x33 - Left Center
0x34 - Center Center
0x35 - Right Center
0x36 - Left Bottom
0x37 - Center Bottom
0x38 - Right Bottom
0x39 - Left, using current y-coordinate
0x3A - Center, using current y-coordinate
0x3B - Right, using current y-coordinate
0x3C - Top, using current x-coordinate
0x3D - Center, using current x-coordinate
0x3E - Bottom, using current x-coordinate
<Data>
This field has a maximum length of
75
characters. Use 0x03 (ETX) as last
char, if less characters are used.
<ALIGN>
0x30-0x3E
<DATA>
"…" [0x03]
PARAMETERS
V
2.0
This command set refers to SG15
plus
firmware version 3.03 and higher.
SUBCOMMAND