User's Manual

Scantech-ID Shuttle
C
SG-15
Colour
33
Notes:
1. At start-up and Wifi-Enable=On, the assignment of the WLAN IP-address is
done as follows:
1. When DHCP is enabled and a DHCP-service is available on the network,
the SG-15 will use the IP-address assigned by the DHCP-service
(the Access Point becomes transparent for any LAN network with an
active DHCP-service that answers first in time).
2. When DHCP is enabled but no DHCP-service is available on the network,
the SG-15 will use 192.168.4.201 as default IP-address.
3. When DHCP is disabled the SG-15 will use the static IP-address
value (192.168.4.200 factory default).
2. SG-15
Colour
Wi-Fi devices provided by Scantech-ID support the hidden SSID
feature (controlled by the Access Point).
3. If a Default Gateway is required for the Wi-Fi network then make sure that
the Default Gateway for LAN is omitted (the reserved field for this must be
empty).
4. At start-up and Wifi-Enable=On, the wifi-driver will immediately attempt to
set-up a connection with the given SSID. If the Access Point is not available,
the SG-15 will continue searching for the SSID until it finds it.
5. WLAN authentication data is never stored on the device itself.
6. The password for the SSID can be made visible with the tick-box
Show Password.
7. The button « Save Only » allows you to change the Wifi settings without
actually activating the Wifi connection. This is useful when configuring Wifi
without an Access Point i.e. it avoids unnecessary waiting for connection
timers to time-out.
8. The WPA/WPA2-Enterprise implementation supports 802.1x authentication by
means of a RADIUS server. The fields Username and Password must match
with those registered on the RADIUS server.
Note: The feature Validate Server Certificate is not yet implemented.