User's Manual

Scantech-ID Shuttle
C
SG-15
Colour
7
Spanish:
El scanner SHUTTLE
C
reune las normas de seguridad IEC 825-1 (1993) para un producto laser de
Clase 1. Y también reune las normas U.S. 21CFR1040 que se aplican a un producto laser de Clase IIa.
Se debe evitar mirar muy fijo en luz lasérica directa.
English:
The SHUTTLE
C
scanner complies with safety standard IEC 825-1 (1993) for a Class I laser product.
It also complies with U.S. 21CFR1040 as applicable to a Class IIa laser product.
Avoid long term viewing of direct laser light.
Optical:
The use of optical instruments with this product will increase eye hazard. Optical instruments include
binoculars, microscopes and magnifying glasses but do not include eyeglasses worn by the user.
Radiant Energy:
The SHUTTLE
C
uses a low-power laser diode operating at 630…670 nm in an opto-mechanical scanner
resulting in less than 0.6 mW peak output power. Laser light observed at 13 cm (5.1 in.) above the
window through a 7 mm (0.28 in.) aperture and averaged over 1000 seconds is less than 3.9 µW per
CDRH Class IIa specification. Do not attempt to remove the protective housing of the scanner, as
unscanned laser light with a peak output up to 0.8 mW could be accessible inside.
Laser Light Viewer:
The scanner window is the only aperture through which laser light may be observed on this product.
A failure of the scanner motor, while the laser diode continues to emit a laser beam, may cause
emission levels to exceed those for safe operation. The scanner has safeguards to prevent this
occurrence. If, however, a stationary laser beam is emitted, the failing scanner should be disconnected
from its power source immediately.
Adjustments:
Do not attempt any adjustments to or alteration of this product. Do not remove the scanner’s
protective housing. There are no user-serviceable parts inside.
CAUTION
Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous laser light
exposure.