Operator's Manual

15
200905 - 3 IN. (7.6 CM) CHIPPER SHREDDER
ASSEMBLY
ASSEMBLY
Your chipper-shredder requires some assembly. This unit ships
from our factory without oil. It must be properly serviced with fuel
and oil before operation.
If you have any questions regarding the assembly of your chipper-
shredder, call our Technical Support Team at 1-877-338-0999.
Please have your serial number and model number available.
Unpacking
1. Set the shipping crate on a solid, flat surface
2. Carefully cut the shipping bands and remove lid of shipping
crate.
3. Locate all hardware before beginning assembly.
1) Install the Wheels
1. Slide the wheel onto the axle.
2. Slide the 15mm washer onto the axle so that it sits against
the wheel.
3. Thread the M8 x 20mm bolt into the axle hole and tighten
securely using a 12mm socket or wrench.
4. Align the tabs on the wheel cap with the holes on the wheel
center hub and snap into place.
2) Install the Chipper Chute
1. Align the holes on the base of the chipper chute with the
threaded studs on the impeller housing and push the chipper
chute flush against the impeller housing.
2. Thread the M10 lock nuts onto the threaded studs and tighten
securely using a 15mm socket or wrench.
3) Install the Shredder Hopper Support
Bracket
1. With the angled part of the bracket pointing towards the
engine, align the holes of the bracket with the holes on the
top of the impeller housing.
2. Insert two M8 x 20 flange bolts through the holes on the
impeller housing and shredder hopper support bracket from
the impeller housing side.
3. Thread two M8 lock nuts onto the flange bolts and tighten
securely using 12mm and 10mm sockets or wrenches.
4) Install the Shredder hopper
1. Insert the shredder hopper into the top of the impeller housing
with the angled part facing the engine. Slide the threaded
studs on the angled part of the shredder hopper into the slots
on the shredder hopper support bracket that was installed in
step 3 while also ensuring that the slots on the bottom of the
shredder hopper slide over the lock nuts that are inside the
impeller housing. Ensure that the four holes on the shredder
hopper are aligned with the 4 holes on the impeller housing
(1 on either side and 2 on the rear).
2. Thread two M6 lock nuts onto the threaded studs to secure
the shredder hopper to the shredder hopper support bracket
and tighten securely using a 10mm socket or wrench.