Instruction Manual

AUTOMATIC TRANSFER SWITCH WITH aXis CONTROLLER™ MODULE
SPECIFICATIONS
14
SPECIFICATIONS
Model 102006 102007 102008 102009 102010
Enclosure Style NEMA 3R Outdoor
Maximum Amps 200 150 100
Nominal Volts 120/240
ETL Listed UL STD NO. 1008
CSA STD C22.2 No.
178.1
UL STD NO. 1008
CSA STD C22.2 No.
178.1
Load Management Circuits 4
Weight 43 lbs (19.6 kg)
Height 28 in. (710 mm)
Width 20 in. (507 mm)
Depth 8.3 in. (210 mm)
Technical Specifications
– 22kAIC, no short-time current rating.
– Suitable for use in accordance with the National Electrical
Code, NFPA 70.
– Suitable for control of motors, electrical discharge lamps,
tungsten filament lamps, and electrical heating equipment,
where the sum of the motor full load ampere ratings and the
ampere ratings of the other loads does not exceed the ampere
rating of the switch, and the tungsten load does not exceed
30% of the switch rating.
– Continuous load not to exceed 80% of switch rating.
– Line voltage wiring: Cu or AL, min 60°C, min AWG 1 – max
AWG 000, torque to 250 in-lb.
– Signal or Com Wiring: Cu only, min AWG 22 – max AWG 12,
torque to 28-32 in-oz.
– All connection lugs are rated AL9CU - 90°C rated
NEMA 3R – This type of enclosed ATS is a weatherproof enclosure
and required for exterior installations by code. The enclosure
has knockouts on the bottom and side, and requires water tight
connections when installed outside per code. This enclosure can
also be used inside.
WARRANTY
Each Champion transfer switch or accessory is guaranteed against
mechanical or electrical failure due to manufacturing defects
for a period of 24 months following shipment from the factory.
The manufacturer’s responsibility during this warranty period
is limited to repair or replacement, free of charge, of products
proving defective under normal use or service when returned to
the factory, transportation charges prepaid. Guarantee is void
on products that have been subjected to improper installation,
misuse, alteration, abuse or unauthorized repair. The manufacturer
makes no warranty with respect to the fitness of any goods for
a user’s particular application and assumes no responsibility for
proper selection and installation of its products. This warranty is
in lieu of all other warranties, expressed or implied, and limits the
manufacturer’s liability for damages to the cost of the product.
This warranty gives you specific legal rights, and you may have
other rights, which vary from state to state.