Instruction Manual

AUTOMATIC TRANSFER SWITCH WITH aXis CONTROLLER™ MODULE
INSTALLATION
12
WIFI Setup Method
1. Use a WiFi enabled device (laptop, smart phone, tablet, etc.)
in near proximity to the ATS.
2. Search and Connect to network name (SSID) “Champion
XXXX” where XXXX will match the last four digits of the serial
number that is printed on the control board. The password
for the network is located on a decal on the dead front of the
ATS.
3. After connecting, open your device’s web browser. Many
times the Champion aXis Controller
TM
Home Standby
Generator Settings Page will autoload however if that is not
the case, refresh the browser or change the web address to
anything.com. As your device attempts to reach the internet
the WiFi module in the ATS will redirect your browser to the
Champion aXis Controller
TM
Home Standby Generator Settings
Page.
If the device’s web browser does not load the Champion aXis
Controller™ Home Standby Generator Settings Page but
rather stays connected to the internet, turn off mobile data
on the device (if applicable) and make sure the device is not
connected to any other networks.
Note: During the setup the device will disconnect from the
internet. The Champion WIFI is a direct connection between
the device and the ATS and it does not connect to the
internet.
If the device is still not connecting, wait 2 minutes and try to
connect with the web browser once again.
4. On the Champion aXis Controller
TM
Home Standby Generator
Settings Page, set the date and time. Use either the drop-
down boxes or the “USE THIS DEVICE’S DATE & TIME” button
to set the time and date. Confirm and Save the settings
before continuing.
5. Set the HSB exercise frequency and schedule. Confirm and
Save the settings before continuing.
6. Wireless network settings are not used at this time. The
default values (shown below) should not be adjusted.
7. The time, date, and exercise information have now been setup
for the aXis ATS and HSB. You can close your browser and
disconnect from the WIFI, or skip to step 2 in the next section
“ATS & HSB STATUS USING WIFI”.
ATS and HSB Status Using WIFI
1. Using a WIFI enabled device, connect to the “Champion HSB”
WIFI network following steps 1, 2, and 3 from WIFI Setup
Method.
2. After loading the Home Standby Generator Settings page,
locate and click the icon at the bottom right corner of the
page.
3. You are now viewing the ATS and HSB status page. Items
such as voltage, frequency, current, etc. can all be viewed for
both utility and HSB power. All of the information is live. There
are three tabs located at the top of the page.
ATS, GEN, and LMM. Each tab will display the status for
the Transfer Switch, Home Standby Generator, or Load
Management Module(s) respectively.
4. When finished viewing the status of the ATS, Generator, and
LMM, close your browser and disconnect from the WIFI.