User Manual

100301 ENGLISH

OPERATION AND PARTS

Paralleling one 2800W-3500W inverter

and one 2000W inverter

1. Inverters to be turned off and all electrical loads

disconnected before installing parallel kit.

2. Align the inverters in the same direction in a “V”

conﬁguration at a minimum of 18 in. [45 cm] apart.

3. Clamp the parallel kit to the left handle of the

inverter on the left of the “V”.

4. Connect the 2800W-3500W inverter.

5. Connect the 2000W inverter by removing the

adapter connectors from the back of the parallel kit.

Remove the connector end cap and insert the RED

power lead into the RED adapter connector and

then into the RED receptacle and the BLACK power

lead into the BLACK adapter connector and then

into the BLACK receptacle.

6. Start engine of both inverters according to inverter

Owner’s Manual. Observe the green output indicator

light on both inverter panels. The light will blink

during start up and will be solid when loads may be

connected.

7. Connect electrical loads to parallel or inverter

panels up to the receptacles rated amperage. Never

exceed the speciﬁed capacity of the receptacle.

8. Follow the instructions in the inverter Owner’s

Manual for turning off the inverter.