User Manual
3
ENGLISH 100301
OPERATION AND PARTS
Paralleling two 2800W-3500W inverters
1. Inverters to be turned off and all electrical loads
disconnected before installing parallel kit.
2. Align the inverters in the same direction in a “V”
configuration at a minimum of 18 in. [45 cm] apart.
3. Clamp the parallel kit to the left handle of the
inverter on the left of the “V”.
4. On each inverter, remove the connector end cap and
insert the RED power lead into the RED receptacle
and the BLACK power lead into the BLACK
receptacle.
5. On each inverter, connect the grounding wire to the
grounding terminal on the inverter.
6. Start engine of both inverters according to inverter
Owner’s Manual. Observe the green output indicator
light on both inverter panels. The light will blink
during start up and will be solid when loads may be
connected.
This kit is intended for the use with Champion Power
Equipment inverters with a least one inverter being
2800W-3500W, and with the ability to parallel. Please
refer to your inverter Owner’s Manual for safety rules,
start up, and shut down procedures, specifications, and
troubleshooting.
The total output of this kit will depend on the size of the
inverters connected to it. With no devices plugged into
the inverters themselves, the combined output can be
determined from the chart below.
If not spaced apart, the exhaust heat from one unit
may discolor or melt the plastic on the other unit.
WARNING
Models Combined
100265
(1900)
100266
(2000)
100267-Dual Fuel
(2520-LPG/2800-Gasoline)
100269
(3100)
100270
(3200)
100271
(3100)
100272
(3200)
100265 (1900)
3500
100266 (2000)
3500 3500
100267-Dual Fuel
(2520-LPG/2800-Gasoline)
4100-LPG
4400-Gasoline
4100-LPG
4400-Gasoline
4800-LPG
5300-Gasoline
100269 (3100)
4700 4700
5300-LPG
5500-Gasoline
5800
100270 (3200)
4700 4700
5300-LPG
5500-Gasoline
5800 5800
100271 (3100)
4700 4700
5300-LPG
5500-Gasoline
5800 5800 5800
100272 (3200)
4700 4700
5300-LPG
5500-Gasoline
5800 5800 5800 5800
7. Connect devices to parallel or inverter panels up to
the receptacles rated amperage. Never exceed the
specified capacity of the receptacle.
8. Follow the instructions in the inverter Owner’s
Manual for turning off the inverter.
Paralleling two 2800W-3500W inverters Cont’d.
Combined Inverter Parallel Output (Watts)*
* The maximum output of the 50A receptacle is 6000W and 30A receptacle is 3600W.