磷酸铁锂电池说明书 LiFePO4 Ba�ery User Manual In order to use this product correctly, please read this instruc�on carefully and be familiar with the opera�on steps. Please keep this manual for your reference.
1. Product brief introduc�on Protec�on func�on of BMS This product is a fully func�onal lithium iron phosphate ba�ery pack management system, with single overvoltage/undervoltage, total undervoltage/overvoltage, charge/discharge overcurrent, high temperature, low temperature and short circuit protec�on and recovery func�ons. Accurate measurement of SOC and SOH health status sta�s�cs are realized in the charging and discharging process. Realize voltage balance during charging process.
28 4.1.2 Inspec�on: Check whether the ba�ery model and accessories are complete 4.1.3 Protec�on: Wear protec�ve equipment such as gloves and goggles 173 (1280Wh) 12.8Volt 100Ah 220 L i F e P O 4 B AT T E RY -Avoid short circuit -keep sparks,flame away -Do not immerse the battery in water B a � e r y c a p a c i t y / Vo l ta g e Constant voltage charge (25℃) -Charge Voltage: 14.60V -Discharge cut-off Voltage: 10.00V -Max.Charge Current：100A -Max. Discharge Current：100A 100% www.championpower.
5. LCD Instruc�on Use the func�on key to switch to the voltage mode and power mode one by one. Refer to the below: supported, and if it is supported, it will enter the dashboard interface. If it is not supported, it will prompt the user that the device is not supported and disconnect. B a�e r y ca p a c i t y / Vo l ta ge B a�e r y ca p a c i t y / Vo l ta ge 100 % 12.8 V 6.
6.5 Basic ba�ery informa�on reading ◎Read the basic informa�on of the ba�ery, display the current ba�ery t emperature, and the number of ba�ery cycles. ◎Read single cell voltage and charge and discharge curves ◎Read the ba�ery protec�on informa�on, so that the user can be�er understand the cause of the current power outage, so as to take �mely countermeasures 6.
.8 Func�on se�ngs Users can set their own func�ons such as charge and discharge, load detec�on, balance func�on, temperature detec�on, etc. 6.9 APP se�ngs Users can set the bluetooth name of the ba�ery by themselves on this page 7.Precau�ons To prevent possible ba�ery leakage, heat genera�on, and fire, please observe the following precau�ons: ◎Please use a special charger for lithium iron phosphate ba�ery when charging. ◎It is strictly forbidden to immerse the ba�ery in seawater or water.
9. Others ◎If the customer needs to use the ba�ery for equipment beyond the specifica�on in the document, or use the ba�ery under the usage condi�ons beyond the specifica�on in the document, please contact with supplier in advance. It is necessary to carry out specific experimental tests to verify the performance and safety of the ba�ery under the use condi�ons. ◎Our company is not responsible for any accident caused by using the ba�ery under condi�ons other than those specified in the document.
