User Manual

100464 - 9200W PORTABLE GENERATOR
IMPORTANT SAFETY INSTRUCTIONS
9
Quickstart Label Symbols
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of
these symbols will allow you to more safely operate the product.
Starting the Engine
1. Check Oil Level. Recommended oil is 10W-30.
2. Add gasoline with a minimum octane rating of 85 and an
ethanol content of 10% or less by volume.
3. Turn the fuel valve to the “ON” position.
4. Press the ignition switch to the “ON” position.
5. Move choke lever to “CHOKE” position.
6. Pull the starter cord.
7. Move the choke lever to “RUN” position.
8. Plug in desired device.
Stopping the Engine
1. Turn off and unplug all electrical loads.
2. Turn the fuel valve to the “OFF” position.
3. Press the ignition switch to the “OFF” position.
For Electric Starting, see starting instructions in page 17.
1 2 3 4 5 6 7 1 2
3
8
10W-30


1040-L-OP-E
K CG1 376 152 2945186
ColorsLPN 1040-L-OP
Rev E
Size 243 x 35 mm
Artwork Notes
3mm corner radius; 2mm safe margin
Revision Changes
B: Reduce length 25 mm per Tyler
C: Swap the step 2 and 3 for stop per Tyler
D: Swap step 2 and 3 for stop per Scott S. to match
manual template
E: Fuel valve simplified/updated
This artwork belongs to Champion Power Equipment. The contents are confidential and privileged and shall not be disclosed to or used by or for
outside parties without the explicit consent of Champion Power Equipment.