Operating Guide

ENGLISH 100198

OPERATION

Located on the outlet ﬂange is the priming plug.

Remove the priming plug and ﬁll pump body to the very

top of outlet ﬂange with water. Reinstall the priming

plug. As the engine starts up, this will start the draw of

liquid into the pump. Located within the pump assembly

is the one-way valve. As you prime the pump housing

this one-way ﬂap valve shuts off the opening to the

suction hose. The priming process is only required when

the pump housing is not full of water.

Priming the Pump

DO NOT run the pump dry.

Running the pump dry can destroy the pump seals

and will void the warranty. If the pump was running

while dry, stop the engine and allow it to cool

thoroughly before ﬁlling the chamber with water.

WARNING

Ensure the priming plug is secure before pump

operation, if not secure the priming plug could be

ejected and water or other liquids could be pumped

through the top of the outlet ﬂange.

NOTE