User Guide

CTM-110/120 Installation & Operation Manual
Page 17
1702-0037 Rev 3.2
8.3 Panel LED Indicators
There are four LED indicators on the CTM-110 and CTM-120 panel. These are used to
show the status and operation of the modem.
PWR This LED shows the power status of the modem:
On solid = the modem is on and able to connect
Flash quickly = the modem is shutting down
Flash slowly = the modem is in standby mode
Off = the modem has no power connected
CELL This LED shows the status of the modem on the CDMA network:
Flashing = the modem is attempting to register on the network
On solid = the modem has registered on the network
TX This LED shows that data is being transmitted:
Off = no data is being transmitted
On or flashing = data is being transmitter
(Combined with RX on the CTM-120)
RX This LED shows that data is being received:
Off = no data is being received
On or flashing = data is being received
GPS (CTM-120 only) This LED shows the status of the GPS module:
Flashing = the GPS module is obtaining a position fix
On solid = the GPS module has obtained a valid position
8.4 Carrier Activation Wizard
The first time the Chameleon Controller Software is run with a new CTM-110/120 modem it
will invoke the Activation Wizard. Prior to running the software it is necessary to obtain an
account from Telus Mobility or your dealer – you will be provided with a 6 digit “lock code”
along with the modems telephone number.
Run the Chameleon Controller Software by double clicking on the Chameleon Icon that was
placed on the desktop during the software installation. Select the serial COM port that the
modem is connected to - this question may be suppressed in future by checking the box don’t
tell me about this again.
The Modem Activation Wizard will start:
Enter the 6 digit lock code and the 10
digit telephone number as provided
by Telus. Click Next and follow the
instructions to complete the modem
activation.