Use and Care Guide

Getting Started
Unpacking
-This product has been packaged to protect it against transportation damage. Remove all
packaging materials from around and inside the appliance, but do not remove any foam
insulation surrounding the pipes at the back. Keep the original packaging carton and materials
in the safe place; it will help prevent any damage if the product needs to be transported in the
future , and you can use it to store the appliance when it is not in use. If the carton is to be
disposed of, please recycle all packaging materials where possible.
-Plastic wrapping can be a suffocation hazard for babies and young children, so ensure all
packaging materials are out of their reach and disposed of safely.
-Parts: Check to ensure you have all the parts pictured on the previous page spread.
-Unwind the power cord to its full length and inspect it for damage. Do not use the appliance if
the appliance or its cord have been damaged or are not working properly. In case of damage,
contact our support line (1-844-455-3474) for advice on examination, repair or return of the
damaged product.
-Make sure the refrigerator is disconnected from the power supply before cleaning the interior
surfaces and all internal accessories with lukewarm water, a soft cloth and a neutral/mild
soap/detergent. This will remove any dust from transit and storage and help remove the typical
smell of a brand-new product. Then dry thoroughly. Important: do not use harsh or abrasive
detergents or powders as these will damage the finish.
Door handle installation
The door handle comes unattached due to packaging restrictions. It is easily attached following the
instructions below.
-Fix the two screws (1) on the door.
-Put the metal handle (2) into the two fixed screws, match the two holes on the handle.
-Fasten the lower two screws (3) on the handle lower.