Door User Manual
Table Of Contents
- Installation Manual for EL Models
- Table of Contents
- Dimensions
- EL25 Installation
- Rotating the Keypad for Vertical Mounting
- Unlocking EL2000
- Locking EL2000
- EL2000 Installation
- Wire Connections to the Unit
- Wire Specs and Run Distances
- Power Wire Specs and Run Distances
- Grounding the Units
- Wiring 1 Unit to Telco Line
- Wiring Multiple Units to Telco Line
- Wiring with No Telco Line
- Wiring to Dedicated Telco Line
- Wiring to an Internal Phone System
- Connection To An NPBI System
- Wiring a Door Strike Lock
- Wiring a Maglock
- Wiring a Gate Operator
- Wiring a Key Switch/PIR/REX
- Wiring a Door Sensing Device
- Wiring the AutoCall Feature
- Wiring a Radio Frequency Module
- Wiegand Card Reader/Keypad
- Wiring a Postal Lock Switch - EL25 Models Only
- Wiring an Internal Camera [CCTV]
- Wiring Power to the Unit
- Powering Up and Checking the LEDs
- Troubleshooting
- Repair Parts
- Your System Diagram
- Your Wiring Configuration
- Accessories
- FCC and DOC Requirements
Page 3
EL25 Installation
EL25 Installation
DO NOT overload the removable
terminal block connectors.
One wire per hole.
DO NOT pinch wires when
closing and locking the unit.
Rotating the Keypad for Vertical Mounting
Screw
Notch
1
2
3
Bracket
Keypad
Main Circuit
Board
Main Circuit Board Connections
J200 - Speaker
J402 - Light
J404 - Call Button Board
ONLY Vertical
Mounting Position
J401 - Keypad
J406 - Light
J201 - Microphone
NOTE: Bracket notch lines up
with ribbon cable on keypad.
Caution! A Static Discharge can
Damage Circuit Boards
For EL25 ONLY
Caution! A Static Discharge can Damage Circuit Boards
1
Unlock Unit
2
Carefully Lift Cover Up
then Slide Out on Hinges
3
Unplug the 2 Main Harnesses
4
Line up Notch with
Screw and Push
Hinge Out
5
Remove Back Mounting Plate from Cover
1
Disconnect all Plugs from Main Circuit Board and
Remove Board. (4 Screws)
2
Remove Bracket. (4 Screws)
3
Rotate Keypad 90 Degrees Clockwise.
4
Reverse the Sequence to Reassemble Unit.
NOTE: This unit is for surface mount applications only.