Door User Manual
Table Of Contents
- Installation Manual for EL Models
- Table of Contents
- Dimensions
- EL25 Installation
- Rotating the Keypad for Vertical Mounting
- Unlocking EL2000
- Locking EL2000
- EL2000 Installation
- Wire Connections to the Unit
- Wire Specs and Run Distances
- Power Wire Specs and Run Distances
- Grounding the Units
- Wiring 1 Unit to Telco Line
- Wiring Multiple Units to Telco Line
- Wiring with No Telco Line
- Wiring to Dedicated Telco Line
- Wiring to an Internal Phone System
- Connection To An NPBI System
- Wiring a Door Strike Lock
- Wiring a Maglock
- Wiring a Gate Operator
- Wiring a Key Switch/PIR/REX
- Wiring a Door Sensing Device
- Wiring the AutoCall Feature
- Wiring a Radio Frequency Module
- Wiegand Card Reader/Keypad
- Wiring a Postal Lock Switch - EL25 Models Only
- Wiring an Internal Camera [CCTV]
- Wiring Power to the Unit
- Powering Up and Checking the LEDs
- Troubleshooting
- Repair Parts
- Your System Diagram
- Your Wiring Configuration
- Accessories
- FCC and DOC Requirements
Page 20
Wiring Power to the Unit
Wiring Power to the Unit
The 110 VAC outlet must be dedicated to the unit ONLY. This outlet should be wired back to its own 10 Amp
minimum circuit breaker. This will prevent two problems:
• Other equipment cannot introduce spikes, noise, surges or dips into the power circuit.
• The system’s operation will not be affected if any other equipment develops a short circuit across the
power line.
Connect the transformer into a 110 VAC outlet after all connections have been made. Any other type of outlet will
cause damage to the system.
IO Input Board
J2
J3
J5
J7
J6
J4
POSTAL
AUTO
J1
POWER
12VAC/DC
OffOff
OffOff
OnOn
OnOn
OnOn
OffOff
OffOff
OffOff
OnOn
OffOff
OffOff
EL Model
Main
Room
Eug. Rm
Oper. Rm
Eug. Dept.
Manu. 1 Rm
Main Dept.
Manu. 2 Rm
Air (1)
Conditioner
Air (2)
Conditioner
Conference
Room 1
Conference
Rm 2, 3
Refer.
Bus 1, 2, 3
Conference
Room 2
Comp.
Serve 2
Comp.
Serve 1
Polarity Does Not Matter
(See table on page 7 for AWG)
Dedicated 10 Amp
Minimum Circuit
AC Power
12 VAC or 16 VDC
110 VAC
Dedicated Outlet
EL Series Unit
MUST be
Properly
Grounded!
See Page 8.
Input Board
(See page 6)