Installation Guide

LED Status Indicators
What You See What It Means
Solid White Smart Garage™ Camera
is powering up.
Flashing Blue Ready to be set up in the
myQ
®
App.
Solid Blue Connected to your mobile
device. You are not yet
connected to the Internet.
If this persists after
setup, check your home
router and Internet.
Flashing Blue
and Green
Connecting to Wi-Fi and
connecting to the myQ
®
App.
Flashing Green Connected to the router,
but there is no internet.
Solid Green Connected to the myQ
®
App.
What You See What It Means
Flashing
Purple
Receiving firmware
updates.
Flashing Red Camera overheating.
Solid Red Motion sensing active.
One Year Limited Warranty
The Chamberlain Group LLC warrants to the first
consumer purchaser of this product that it is free
from defect in material and/or workmanship for a
period of 1 year from the date of purchase.
Software Agreement
Use of this product and the software embedded
within the product are subject to the copyright
notices, terms, and conditions accessible in the
myQ
®
App. Open the App Menu and select Help,
and then License and Terms of Use for more
information.
Need Help?
Go to: support.chamberlaingroup.com
NOTICE: This device complies with part 15 of the FCC rules and Innovation,
Science and Economic Development Canada license-exempt RSSs. Operation
is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device must be installed to ensure a minimum 20 cm (8 in.) distance is
maintained between users/bystanders and device.
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules and Industry Canada ICES
standard. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
l
Reorient or relocate the receiving antenna.
l
Increase the separation between the equipment and receiver.
l
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
l
Consult the dealer or an experienced radio/TV technician for help.
The device for operation in the band 5150-5250 MHz is only for indoor use to
reduce the potential for harmful interference to co-channel mobile satellite
systems.
© 2022, Chamberlain Group LLC
All Rights Reserved
myQ
®
, the myQ
®
logo, and the LiftMaster
®
logo are
registered trademarks of the Chamberlain Group LLC.
Wi-Fi
®
is a registered trademark of Wi-Fi Alliance
114-5836-000