User's Manual
2
Mount Doorbell
Mount doorbell with small
silver screws. Screw the top
two screws halfway into the
mounting surface. Place back of
doorbell over screws. Tighten
screws.
Choose a mounting location for the doorbell that is within range of the intercom(s) to ensure the doorbell will work properly. The
doorbell can be mounted using the provided screws or by using the double-sided mounting tape. It is recommended to use the mounting
tape on surfaces such as metal or glass.
MOUNTING WITH SCREWS
Put the remaining silver screws
into the bottom holes of
doorbell. Tighten screws.
Peel off white paper from
mounting tape. Firmly press
mounting tape on back of
doorbell.
Peel paper from mounting tape.
Firmly press doorbell onto
mounting surface.
Clean back of doorbell and
mounting surface using the
alcohol wipe.
MOUNTING WITH TAPE
Secure cover with the two large
black screws.
Secure Cover
1
2
1
2
3
1
Press and hold the learn button on
the new intercom until a beep is
heard.
Within 10 seconds press and hold the learn button on any
intercom in the existing network until a beep is heard. Wait
until all the lights go out on the intercom (it may take up to
3-1/2 minutes for a secure network to be established).
M
ON
I
TOR
H
O
L
D
O
F
F
1
3
2
4
VO
L
U
ME
T
A
L
K
A
C
T
IV
E
Program Intercom and Doorbell into Existing Network
1
2
3
To add the doorbell to the
network, press and hold the
learn button on any intercom
in the existing network until a
beep is heard.
Within 10 seconds press and
hold the learn button on the
new doorbell until a beep is
heard.
M
ON
I
TOR
H
O
L
D
O
F
F
1
3
2
4
VO
L
U
ME
T
A
L
K
A
C
T
I
V
E
1
2
Do not program the new intercom and doorbell to each other before adding them to the existing network or they will form a separate
network and the memory will need to be cleared. First, program the intercom to the existing network, then program the doorbell. Before
beginning, ensure that all intercom are on the same channel (refer to Channel Button in the Operation section).
Repeat for any additional intercoms or doorbells.
Test by holding the talk button on
the new intercom until a beep is
heard. This will initiate a call to the
other intercoms in the network.
Press and hold the talk button on
any network intercom to answer the
call.
DOORBELL
INTERCOM
V
OL
UME
MONIT
O
R
C
HAN
NE
L
HO
L
D
O
F
F
A
CTI
V
E
T
A
L
K
1
3
2
4
Wait about 30 seconds for the
intercoms to sync, then test by
pressing the call button on the
doorbell. The call will be heard
on the intercoms in the network.
Press and hold the talk button
on any intercom to reply.
V
OL
U
ME
MONIT
O
R
C
HAN
NE
L
HO
L
D
O
F
F
A
CTI
V
E
T
A
L
K
1
3
2
4
3