Programming Instructions

CLICKER
®
Models KLIK1U & KLIK1C
Program to Genie
®
IntelliCode
®
2
BEFORE STARTING:
You MUST have a Genie
®
IntelliCode
®
2
remote control with at least one button
already programmed to the opener.
SETUP THE CLICKER
®
REMOTE CONTROL:
2
Press the program
button until the
LED lights.
Remove the front cover
of the Clicker
®
remote.
1
Press the
program button.
43
Select a button to program and
press that button 5 times, ensuring
the LED stops
flashing after
each press.
PROGRAM TO THE GENIE
®
INTELLICODE
®
2 GARAGE DOOR OPENER:
67
Release the Program/Set
button and only the round
LED will be lit in BLUE.
On the garage door opener,
press and hold the Program/Set
button until both the long and
short LED light up BLUE.
Press and release the
Program/Set button and the
long LED will flash PURPLE.
5 8
On the Genie
®
remote control, press
and release the button that is already
programmed to the garage door opener.
Both LED’s will flash PURPLE.
91011
On the CLICKER
®
remote control, press and
release the same button you have already set
up to control your garage door opener in the
previous section. Both LED’s on the garage
door opener will light up PURPLE.
On the CLICKER
®
remote control,
press and release the same button
again. Both LED’s on the garage
door opener will light up BLUE.
On the CLICKER
®
remote control, press and release the
same button again. This will activate the garage door opener
and programming is complete.
If the door does not activate, return to Step 1.
Genie and IntelliCode are trademarks of GMI Holdings, Inc.
© 2011, Clicker Corporation
SPCMB01 All Rights Reserved