Instructions / Assembly

36
Operation
Remote Control (continued)
PROGRAM USING THE LEARN BUTTON
1. Locate the Learn Button.
2. Press and immediatelyrelease the Learn button.The Learn LED will glow steady for 30
seconds. Within 30 seconds...
3. Remote Control: Press and hold the button on the remote control that you wish to use.
Keyless Entry: Enter a 4-digitpersonal identification number (PIN) of your choice on the
keylessentry keypad.Then press and hold the ENTER button.
Release the button when the garage door opener lightsblink or two clicksare heard. When replacing
the lightlens cover, ensure the antenna wires are hanging straightdown.
LEARN LED
LEARN
Button
“click”
“click”
1-2 3
PIN
To watch a video, go to tinyurl.com/lcsf6xt
HomeLink
®
If your vehicle is equipped with HomeLink, a Compatibility Bridge
TM
(notincluded) may be necessary for
certain vehicles. Visitbridge.chamberlain.comto find outifa Bridge is needed.
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the LEARNbutton on garage door opener until the learn LED goes out
(approximately 6 seconds).All remote control and keyless entrycodesare nowerased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (Including MyQ
®
enabled accessories)
1. Press and hold the LEARNbutton on garage door opener until the learn LED goes out
(approximately 6 seconds).
2. Immediately pressand hold the LEARN button again until the learn LED goes out. All codes
are nowerased.Reprogram anyaccessoryyou wish to use.