Instructions / Assembly

35
Operation
Motion Detecting Control Panel (continued)
LOCK
The LOCK feature is designed to prevent activation ofthe garage door opener fromremote controls
while still allowing activation from the door control and keyless entry. Thisfeature is useful for added
peace of mind when the home is empty (i.e.vacation).
l Activate: Press and hold the LOCK button for 2 seconds. The command LEDwill flash as
long asthe lock feature is activated and your handheld remote control will notoperate your
door at thistime.
l Deactivate: Press and hold the LOCK button again for 2 seconds. The command LEDwill
stop flashing and normal operation will resume.
TIMER-TO-CLOSE
DO NOT enable TTC if operatinga one-piece door. The TTC can be turned on or offand the time
interval can be adjusted to 1, 5, and 10 minute intervals. Once the TTC hasbeen setand the door is
open,the selected close interval will blink and begin to count down to close the door.
l Activate: Press and hold the ONbutton until one of the TTC LEDs light up.Then press the
ON button again to cycle through the time interval options (the corresponding TTC LED will
lightfor each time interval).The garage door opener lightbulbs will blinkasconfirmation.
l Deactivate: Press and hold the OFF button until all TTC LEDs turn offand a beep isheard
fromthe motor unit.
l Temporarily hold dooropen(suspendTTC): Press and release the HOLD OPEN button.
Press the HOLD OPEN button again to resume normal TTC operation.
PROGRAM
Any compatible remote controls, wirelesskeyless entry, or MyQ
®
accessoriescan be programmed to
the garage door opener by pressing the Learn button.
ON (TTC)
OFF (TTC)
Comm
and LED
Motion Sensor Switch
LIGHT Button
HOLD OPEN
Butt
on(TTC)
Motion Sensor
Push Bar
1, 5, and
10 Minute
TTC LED
LEARN Button
LOCK Button
Remote Control and Keyless Entry
Pre-programmed remote control included, no need to program the remote.
To add or reprograma remote control,follow the instructions below. Older Chamberlain remote
controlsare NOT compatible, see page 41 for compatible accessories.
PROGRAM USING THE DOOR CONTROL
1. Press the LEARNbutton on the door control to enter Programming Mode.
2. Press the LEARNbutton again, the LEDwill flash once.
3. Remote Control: Press the button on the remote control that you wish to operate your garage
door.
Keyless Entry: Enter a 4-digitpersonal identification number (PIN) of your choice on the
keylessentry keypad.Then press the ENTERbutton.
The garage door opener lights will flash (or two clicks will be heard) when the code hasbeen
programmed.
The command LED
will flash once.
The command LED will
flash once again.
1
2
OR
PIN
? ? ? ?
3