Instructions / Assembly

34
Operation
Using your Garage Door Opener
The garage door opener can be activated through a wall-mounted door control, remote control,
wirelesskeyless entryor MyQ
®
accessory.
When the door is closed and the garage door opener is activated the door will open.Ifthe door senses
an obstruction or is interrupted while opening the door will stop. When the door isin anyposition other
than closed and the garage door opener is activated the door will close.Ifthe garage door opener
senses an obstruction while closing,the door will reverse. If the obstruction interrupts the sensor beam
the garage door opener lightswill blink10 times.However,you can close the door if you hold the button
on the door control or keyless entryuntil the door is fullyclosed.
The safetyreversing sensorsdo notaffect the opening cycle.The safety reversing sensor must be
connected and aligned correctly before the garage door opener will move in the down direction.
Motion Detecting Control Panel
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press the push bar until the garage door
opener activates (it maytake up to 3 presses). Test the door control by pressing the push bar, each
press of the push bar will activate the garage door opener.
ON (TTC)
OFF (TTC)
Command LED
Motion Sensor Switch
LIGHT Button
HOLD OPEN
Button(TTC)
Motion Sensor
Push Bar
1, 5, and
10 Minute
TTC LED
LEARN Button
LOCK Button
MOTION DETECTING CONTROL PANEL FEATURES
PUSH BAR
Press the push bar to open or close the door.
LIGHTS
Light Button
Press the LIGHTbutton to turn the garage door opener lights on or off.When the lights are turned on
theywill stay on until the LIGHT button is pressed again, or until the garage door opener is activated.
Once the garage door opener is activated the lights will turn off after the specified period of time (the
factorysetting is 4-1/2 minutes). The LIGHTbutton will notcontrol the lightswhen the door isin motion.
To change the amount of time the garage dooropener lights will stay on:
Press and hold the LOCK button (approximately 10 seconds) until the garage door opener lights flash.
The time interval is indicated bythe number timesthe garage door opener flashes:
l 1 flash is1-1/2 minutes
l 2 flashes is 2-1/2 minutes
l 3 flashes is 3-1/2 minutes
l 4 flashes is 4-1/2 minutes
To cycle through the time intervalsrepeat the step above.
Light Feature
The lights will turn on when someone enters through the open garage door and the safety reversing
sensor infrared beam isbroken.
l Deactivate: Press and hold the LIGHTbutton (approximately 10 seconds) until the garage
door opener lightsturn on,then off again.
l Activate: Start with the garage door opener lights on. Pressand hold the LIGHTbutton
(approximately 10 seconds) until the garage door opener lightsturn off, then on again.
If the command LEDiscontinuously blinking, the LOCK feature needs to be deactivated.
Motion Sensor
Factorydefaultisset to on. Thisfeature automatically turns on the garage door opener lights when
motion is sensed.The lights will come on for the setperiod oftime, then shut off.Ifusing the garage door
opener light as a worklight disable the motion sensor,otherwise the lightwill turn offautomatically if you
are beyond the range of the sensor.
Activate/Deactivate: Slide the motion sensor switch ON or OFF.