Instructions / Assembly

26
Installation
STEP 14 Wire the Safety Reversing Sensors (continued)
OPTION B PRE-WIRED INSTALLATION
1. Cut the end of the safetyreversing sensor wire, making sure there is enough wire to reach the
pre-installed wires fromthe wall.
2. Separate the safetyreversing sensor wires and strip 7/16 inch (11 mm) of insulation from each
end.Choose two of the pre-installed wires and strip 7/16 inch (11 mm) of insulation from each
end.Make sure thatyou choose the same color pre-installed wires for each sensor.
3. Connect the pre-installed wires to the sensor wires with wire nutsmaking sure the colors
correspond for each sensor. For example, the white wire would connect to the yellow wire and
the white/blackwire would connectto the purple wire.
4. Atthe garage door opener,strip 7/16 inch (11 mm) of insulation from each end ofthe wires
previously chosen for the safetyreversing sensors. Twist the like-colored wires together.
5. Insertthe wiresconnected to the white safetysensor wires to the white terminal on the garage
door opener. Insert the wires thatare connected to the white/black safety sensor wires to the
greyterminal on the garage door opener.
Safety reversing
sensor wires
Pre-installed
wires
White
White/Black
Yellow (for example)
Purple (for example)
Wire nuts (not provided)
Pre-installed wires
Safety reversing
sensor wires
1
3
4
7/16" (11 mm)
2
Purple
Yellow
5
7/16" (11 mm)
Yellow
Purple
To insert or remove the wires from the terminal,
push in the tab with a screwdriver tip.