Instructions / Assembly

24
Installation
STEP 13 Install the Protector System
®
(continued)
OPTION B WALL INSTALLATION
If additional clearance is needed an extension bracket(not provided) or wood blocks can be used.
Make sure each brackethasthe same amount of clearance so they will align correctly.
1. Position the sensor bracketagainstthe wall with the curved arms facing the door. Make sure
there isenough clearance for the beam to be unobstructed. Markholes.
2. Drill 3/16 inch pilotholes for each sensor bracket and attach the sensor brackets to the wall
using lag screws (not provided).
3. Slide the carriage boltinto the sloton each sensor.
4. Insertthe bolt through the hole in the sensor bracket and attach with the wing nut.The lenses
on both sensors should point toward each other.Make sure the lensisnotobstructed by the
sensor bracket.
Lens
Carriage
Bolt
(Not provided)
No more than
6 inches (15 cm)
1 2
(Not provided)
Wing Nut
3 4
OPTION C FLOOR INSTALLATION
Use an extension bracket(not provided) or wood blockto raise the sensor bracketifneeded.
1. Carefully measure the position of both sensor brackets so theywill be the same distance from
the wall and unobstructed.
2. Attach the sensor brackets to the floor using concrete anchors(notprovided).
3. Slide the carriage boltinto the sloton each sensor.
4. Insertthe bolt through the hole in the sensor bracket and attach with the wing nut.The lenses
on both sensors should point toward each other.Make sure the lensisnotobstructed by the
sensor bracket.
(Not provided)
I
e
l
l
1 2
Carriage Bolt
Wing Nut
3 4