Manualshelf

Instructions / Assembly

ManualsBrandsChamberlain ManualsDoors & Windows3/4 HP Durable Chain Drive Garage Door Opener with Plus Lifting Power
11121314151617181920
16
Installation
STEP 6 Install the light bulbs
To preventpossible OVERHEATING of the end panel or lightsocket:
l Use ONLY A19 incandescent (100W maximum) or compactfluorescent(26W maximum) light
bulbs.
l DO NOT use incandescent bulbslarger than 100W.
l DO NOT use compact fluorescent lightbulbs larger than 26W (100W equivalent).
l DO NOT use halogen bulbs.
l DO NOT use short neckor specialty lightbulbs.
1. Pull on the top sides of the lightlens and rotate the lightlens down.
2. Insertan A19 incandescent (100Wmaximum) or compactfluorescent (26W,100W
equivalent) lightbulb into the light socket.
3. Rotate the lensup to close.
NOTE: Do notuse halogen, short neck, or specialty light bulbs as these may overheat the end panel or
light socket. Do not use LED bulbs as they may reduce the range or performance of your remote
controls.
or or
STEP 7 Attach the emergency release rope and handle
To preventpossible SERIOUS INJURY or DEATHfrom a falling garage door:
l If possible,use emergency release handle to disengage trolley ONLY when garage door is
CLOSED. Weakor broken springsor unbalanced door could result in an open door falling
rapidly and/or unexpectedly.
l NEVER use emergencyrelease handle unless garage doorwayisclear of persons and
obstructions.
l NEVER use handle to pull door open or closed. If rope knot becomesuntied,you could fall.
1. Insertone end ofthe emergencyrelease rope through the handle. Make sure that “NOTICE”
is rightside up.Secure with an overhand knot at least1" (2.5 cm) fromthe end of the rope to
prevent slipping.
2. Insertthe other end of the emergencyrelease rope through the hole in the trolley release arm.
Mount the emergency release within reach, but at least 6 feet (1.83 m) above floor, avoiding
contactwith vehicles to prevent accidental release and secure with an overhand knot.
NOTE: If it is necessary to cut the emergency release rope, seal the cut end with a match or lighter to
prevent unraveling. Ensure the emergency release rope and handle are above the top of all vehicles to
avoid entanglement.