Instructions / Assembly

13
Installation
STEP 2 Install the header bracket
You can attach the header bracketeither to the wall above the garage door,or to the ceiling.Follow the
instructionswhich will work bestfor your particular requirements.Do not installthe header bracket
overdrywall.If installing into masonry, use concrete anchors (not provided).
Lag Screw 5/16"-9x1-5/8"
HARDWARE
OPTION A WALL INSTALLATION
1. Center the bracket on the vertical centerline with the bottomedge of the bracketon the
horizontal line asshown (with the arrow pointing toward the ceiling).
2. Mark the vertical set of bracketholes.Drill 3/16" pilot holesand fasten the bracketsecurely to a
structural supportwith the hardware provided.
OPTION B CEILING INSTALLATION
1. Extend the vertical centerline onto the ceiling as shown.
2. Center the bracket on the vertical mark, no more than 6" (15 cm) fromthe wall.Make sure the
arrowispointing away fromthe wall.The bracketcan be mounted flush against the ceiling
when clearance is minimal.
3. Mark the side holes. Drill 3/16" pilotholes and fasten bracketsecurely to a structural support
with the hardware provided.
UP
Wall Mounting
Holes
WALL INSTALLATION
CEILING INSTALLATION
Optional Mounting
Holes
Vertical
Centerline of
Garage Door
Header Wall
Header
Bracket
2x4
Structural
Support
Door
Spring
Garage Door
Highest Point
of Garage
Door Travel
Horizontal
Line
Lag
Screw
UP
Header Wall
Ceiling Mounting
Holes
Finished Ceiling
Vertical
Centerline of
Garage Door
Header
Bracket
6" (15 cm)
Maximum
Door Spring
Garage Door
Lag Screw