Replacement Part List

Adjustments

STEP 1 Program the Travel

Without a properly installed safety reversal system, persons (particularly small children) could be

SERIOUSLY INJURED or KILLED by a closing garage door.

l Incorrect adjustment of garage door travel limits will interfere with proper operation of safety

reversal system.

l After ANY adjustmentsare made, the safetyreversal system MUST be tested. Door MUST

reverse on contact with 1-1/2" (3.8 cm) high object (or 2x4 laid flat) on floor.

While programming, the UP and DOWN buttons can be used to move the door as needed.

1. Press and hold the Adjustment Button until the UP Button begins to flash and/or a beep is

heard.

2. Press and hold the UP Button until the door is in the desired UP position.

3. Once the door is in the desired UP position press and release the Adjustment Button. The

garage door opener lightswill flash twice and the DOWNButton will begin to flash.

IMPORTANT NOTE: For one-piece door installations refer to page 29.

4. Press and hold the DOWNbutton until the door is in the desired DOWN position.

5. Once the door is in the desired DOWN position pressand release the Adjustment Button. The

garage door opener lightswill flash twice and the UP Button will begin to flash.

6. Press and release the UP Button. When the door travels to the programmed UP position, the

DOWN Button will begin to flash.

7. Press and release the DOWN Button. The door will travel to the programmed DOWNposition.

Programming is complete.

* Ifthe garage door opener lightsare flashing 5 times during the steps for Program the Travel, the

programming has timed out.Ifthe garage door opener lightsare flashing 10 times during the steps for

Program the Travel,the safety reversing sensors are misaligned or obstructed (refer to page 28). When

the sensors are aligned and unobstructed,cycle the door through a complete up and down cycle using

the remote control or the UP and DOWNbuttons.Programming is complete.If you are unable to

operate the door up and down, repeat the steps for Programming the Travel.

UP Button

Adjustment Button

DOWN Button

PROGRAMMING BUTTONS

1 2

4 5

6 7

To watch a video, go to tinyurl.com/lkwbnhj