Installation Instructions

8
Assembly
STEP 3 Install the idler pulley
1. Lay the chain/cable beside the rail, asshown.Grasp the end ofthe cable and pass
approximately 12" (30 cm) ofcable through the window. Allow it to hang until Assembly
Step4.
2. Remove the tape fromthe idler pulley. The inside center should be pre-greased. Ifdry,
regrease to ensure proper operation.
3. Place the idler pulleyinto the window as shown.
4. Insertthe idler boltfrom the top through the rail and pulley.Tighten with a 3/8" lockwasher
and nutunderneath the rail until the lock washer iscompressed.
5. Rotate the pulleyto be sure it spins freely.
6. Locate the rail tab.The rail tab isnear the idler pulley on the frontrail section.Use a flat head
screwdriver and liftthe rail tab until the tab is vertical (90º).
Rail
Idler Pulley
Grease Inside
Pulley
Bolt
Chain/cable
Lock Washer
Nut
Bolt
Nut 3/8" Lock Washer 3/8"
HARDWARE
Rail Tab