Installation Instructions

37
Operation
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Pressand hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds).All remote control and keylessentrycodes are now erased.
Reprogram anyaccessory you wish to use.
ERASE ALL DEVICES (Including MyQ
®
enabled accessories)
1. Pressand hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2. Immediately pressand hold the LEARN button again until the learn LED goes out. All codes
are now erased.Reprogram any accessoryyou wish to use.
To Open the Door Manually
To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
l If possible, use emergency release handle to disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced door could result in an open door falling
rapidly and/or unexpectedly.
l NEVER use emergency release handle unless garage doorwayis clear of persons and
obstructions.
l NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
DISCONNECT THE TROLLEY
1. The door should be fully closed ifpossible.
2. Pull down on the emergency release handle so the trolleyrelease arm snapsto the vertical
position.The door can now be raised and lowered as often asnecessary.
TO RE-CONNECT THE TROLLEY
1. Pull the emergencyrelease handle toward the garage door opener so the trolley release arm
snaps to the horizontal position. The trolley will reconnecton the nextUP or DOWNoperation,
either manuallyor by using the door control or remote control.