Installation Instructions

36
Operation
Remote Control and Keyless Entry*
Pre-programmed remote control included, no need to program the remote.
To add or reprograma remote control, follow the instructionsbelow. Older Chamberlain remote
controlsare NOT compatible,see page 41 for compatible accessories.
PROGRAM USING THE DOOR CONTROL
1. Pressthe LEARN button on the door control to enter Programming Mode.
2. Pressthe LEARN button again,the LED will flash once.
3. Remote Control: Press the button on the remote control thatyou wish to operate your garage
door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the
keylessentry keypad.Then pressthe ENTER button.
The garage door opener lights will flash (or two clickswill be heard) when the code hasbeen
programmed.
The command LED
will flash once.
The command LED will
flash once again.
1
2
OR
PIN
? ? ? ?
4
GHI
5
JKL
7
P
RS
8
TUV
9
WXY
0
QZ
*
#
E
NT
E
R
0
QZ
*
#
ENTER
6
MNO
3
* Notincluded with all models.
PROGRAM USING THE LEARN BUTTON
1. Locate the Learn Button.
2. Pressand immediately release the Learn button.The Learn LED will glow steady for 30
seconds. Within 30 seconds...
3. Remote Control: Press and hold the button on the remote control thatyou wish to use.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the
keylessentry keypad.Then pressand hold the ENTER button.
Release the button when the garage door opener lightsblinkor two clicks are heard.When replacing
the light lenscover, ensure the antenna wiresare hanging straight down.
LEARN LED
LEARN
Button
“click”
“click”
1-2 3
PIN
To watch a video, go to tinyurl.com/lcsf6xt
HomeLink
®
If your vehicle isequipped with HomeLink,a Compatibility Bridge
TM
(notincluded) maybe necessary for
certain vehicles.Visit bridge.chamberlain.com to find out if a Bridge isneeded.