Installation Instructions

34
Operation
Using your Garage Door Opener
The garage door opener can be activated through a wall-mounted door control,remote control,
wirelesskeylessentryor MyQ
®
accessory.
When the door is closed and the garage door opener isactivated the door will open.If the door senses
an obstruction or is interrupted while opening the door will stop.When the door isin anyposition other
than closed and the garage door opener is activated the door will close.Ifthe garage door opener
senses an obstruction while closing, the door will reverse.If the obstruction interruptsthe sensor beam
the garage door opener lights will blink10 times. However,you can close the door if you hold the button
on the door control or keylessentry until the door is fully closed.
The safety reversing sensors do notaffect the opening cycle. The safety reversing sensor must be
connected and aligned correctlybefore the garage door opener will move in the down direction.
Multi-Function Control Panel
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener,press the push bar until the garage door
opener activates (itmay take up to 3 presses). Testthe door control by pressing the push bar, each
press of the push bar will activate the garage door opener.
Push Bar
LIGHT Button
LOCK Button
Command LED
LEARN Button
MULTI-FUNCTION CONTROL PANEL FEATURES
PUSH BAR
Press the push bar to open or close the door.
LIGHTS
Light Button
Press the LIGHT button to turn the garage door opener lights on or off.When the lights are turned on
theywill stayon until the LIGHT button is pressed again,or until the garage door opener is activated.
Once the garage door opener is activated the lights will turn off after the specified period of time (the
factorysetting is4-1/2 minutes).The LIGHTbutton will notcontrol the lights when the door is in motion.
To change the amount of time the garage dooropener lights will stay on:
Press and hold the LOCK button (approximately 10 seconds) until the garage door opener lightsflash.
The time interval is indicated bythe number times the garage door opener flashes:
l 1 flash is 1-1/2 minutes
l 2 flashesis2-1/2 minutes
l 3 flashesis3-1/2 minutes
l 4 flashesis4-1/2 minutes
To cycle through the time intervalsrepeatthe step above.
Light Feature
The lightswill turn on when someone enters through the open garage door and the safety reversing
sensor infrared beam is broken.
l Deactivate: Press and hold the LIGHTbutton (approximately 10 seconds) until the garage
door opener lightsturn on,then offagain.
l Activate: Startwith the garage door opener lights on.Press and hold the LIGHT button
(approximately 10 seconds) until the garage door opener lights turn off, then on again.
If the command LEDis continuously blinking,the LOCK feature needs to be deactivated.