Installation Instructions

Adjustments

STEP 1 Program the Travel

Withouta properlyinstalled safety reversal system,persons(particularly small children) could be

SERIOUSLY INJURED or KILLED bya closing garage door.

l Incorrect adjustmentofgarage door travel limitswill interfere with proper operation of safety

reversal system.

l After ANY adjustmentsare made,the safety reversal system MUST be tested. Door MUST

reverse on contactwith 1-1/2" (3.8 cm) high object(or 2x4 laid flat) on floor.

While programming,the UP and DOWN buttons can be used to move the door as needed.

1. Pressand hold the AdjustmentButton until the UP Button begins to flash and/or a beep is

heard.

2. Pressand hold the UP Button until the door is in the desired UP position.

3. Once the door isin the desired UP position press and release the Adjustment Button. The

garage door opener lightswill flash twice and the DOWN Button will begin to flash.

IMPORTANT NOTE: For one-piece door installations refer to page 29.

4. Pressand hold the DOWN button until the door is in the desired DOWN position.

5. Once the door isin the desired DOWN position press and release the Adjustment Button. The

garage door opener lightswill flash twice and the UP Button will begin to flash.

6. Pressand release the UP Button. When the door travelsto the programmed UP position,the

DOWN Button will begin to flash.

7. Pressand release the DOWN Button. The door will travel to the programmed DOWN position.

Programming iscomplete.

* Ifthe garage door opener lights are flashing 5 times during the stepsfor Programthe Travel, the

programming has timed out. Ifthe garage door opener lightsare flashing 10 times during the stepsfor

Program the Travel,the safetyreversing sensors are misaligned or obstructed (refer to page 28). When

the sensors are aligned and unobstructed, cycle the door through a complete up and down cycle using

the remote control or the UP and DOWNbuttons. Programming iscomplete. Ifyou are unable to

operate the door up and down, repeat the steps for Programming the Travel.

UP Button

Adjustment Button

DOWN Button

PROGRAMMING BUTTONS

1 2

4 5

6 7

To watch a video, go to tinyurl.com/lkwbnhj